Original StarFire Desktop Configurator
This StarFire Desktop Configurator Program is for StarFire Position Receiver owners that set the baud rates and update rates of the StarFire Position Receiver to work with NON - Deere applications (i.e. Laptops). It is not tested or supported to work with Windows™ CE, PDAs, or any handheld units such as I-Paqs. This StarFire Desktop Config program will also allow you to update software to the receiver with the proper files attached.
If you are loading new software to your original receiver with Configurator, use the following file to load the software. If you are loading new software to your original StarFire with Configurator, use the following .gst file.
NOTE: Right click on the .gst file and select Save Target As.
Instructions to load receiver software
Original StarFire software (.gst file)
StarFire iTC Configurator
This StarFire iTC Desktop Configurator Program is for StarFire iTC Receiver owners that set the baud rates and update rates of the iTC Receiver to work with NON - Deere applications (i.e. Laptops). It is not tested or supported to work with Windows™ CE, PDAs, or any handheld units such as I-Paqs. This StarFire iTC Desktop Config program will also allow you to update software to the receiver with the proper .gst attached.
If you want to use StarFire iTC Configurator to load software to the receiver, use the following .hex file for iTC.
NOTE: Right click on the .hex file and select Save Target As.